In this section we will deploy a Nutanix Prism Central VM onto our AHV cluster since Prism Central is the multi-cluster manager similar in some ways to vCenter. It will also run as a double nested VM in this scenario, but if you do have problems you can deploy it directly onto Proxmox with the QCOW image Nutanix also provides:

To start log into Prism and click on the Register or deploy new Prism Central:

Choose Deploy since we will be running Prism Central directly on the 3N cluster:

Give the PC VM a name and pick one of the available versions (I am going to pick the N-1 so I can try and update later):

Choose a small VM since an Extra-Small does now allow you to enable the Disaster Recovery services we will want to use for DR replication later:

Put in all your Prism Central VM information:

Wait for the deployment to complete. Since this is a double nested VM running on nested storage it will take some time:


Once the deployment is complete open up you web browser and go to your Prism Central hostname/IP address (https://192.168.105.38:9440/ for me) so we can configure a few things before attaching our AHV cluster. Log in with the default username admin and password Nutnaix/4u and it will prompt you to change the password. Once you have changed the admin password you should be at the dashboard:

After logging in resolve the error as it was likely from the install process:

Next navigate to Network & Security -> System Accounts and change the Prism Central nutanix password from the default (nutanix/4u) to your own to get rid of that error:

Next navigate to Prism Central Settings -> More Settings to we can set a few more things:

From here you can add/edit the DNS servers, NTP servers, or name under Prism Central Management:


With Prism Central setup and the passwords changed go back to your AHV clusters Prism Element and click on Register or deploy new Prism Central again:

This time choose Connect:

Put in your Prism Central IP and credentials and click connect to register your cluster with Prism Central:

After a minute or two your cluster will show that is connected to Prism Central:

And back in Prism Central you will start to see the cluster metrics begin to populate:

This concludes the basic setup of Prism Central.
Leave a Reply